Turn windows features on or off windows 7 powershell

Disclaimer: This has been sourced from a third party syndicated feed through internet. We are not responsibility or liability for its dependability, trustworthiness, reliability and data of the text. We reserves the sole right to alter, delete or remove without notice the content in its absolute discretion for any reason whatsoever. Source: How do I turn windows features on or off using powershell or commandline in windows 7? Skip to content. Suggestion: 1: dism.

FeatureState]::Disabled and bye bye media center. Also, this module requires WMF 3. NET 4. You can enable any Windows feature or you can disable them. Some features are disabled by default.

Windows Features can be enabled or disabled using command line. For checking the status of the features type the command mentioned above. In order to enable any feature, follow the steps below:. Disabling Windows features is very similar to enabling them. Follow the steps below to disable any feature. You will get detailed information about the feature name, description, properties, status and whether it requires restart or not. The benefit of PowerShell over using a command prompt is that PowerShell commands check if the feature is already enabled.

If it is already enabled, the installation action is not performed saving computing time. To get information about windows features through Powershell, open PowerShell in administrative mode and then type. If a feature is not available for installation in installed Windows, we will need to give external source address to install the feature.

The external source can be Windows installation ISO or any drive. Make sure that the path should be given correctly and installation media should be correctly installed. Here we show you how. Make sure to open a Command Prompt with administrative privileges. To get a full list of available features that can be, or are are currently installed on the system:.

The online argument tells DISM that the local system is the target. Format:table is optional and displays the list in a more readable table format. The more at the end is also optional and splits the list into pages. Press Space to show each subsequent page. If you want to filter the list to show just enabled or disabled features, change the DISM command slightly.

Note the Enabled and Disabled words are case sensitive and need to start with a capital letter or nothing will show. The name of the feature is case sensitive and you have to type it in exactly as listed, including any spaces. The information will show a description of the feature and whether a reboot might be needed. Enabling or disabling a feature is pretty simple, the feature name is again case and space sensitive.

Performing several operations at once on the same line is possible. DISM is a powerful tool, for some more technical reading about what it can do, there is a reference document at Microsoft Technet. NET Framework. Newer versions of Windows have the function to view optional features built in. To view the list of features available on the system. Like DISM, the online argument tells the command to work on the local system while the optional ft displays the results in a table and more breaks the list into pages.

To filter the list into enabled or disabled features.